Do not touch the measuring tools of aluminum plate with wet hands
2021-06-24

Aluminum plate may need welding, cutting and other operations because of the different places used in the industry. These operations may require measuring tools to accurately measure the required welding and cutting dimensions. How to deal with the tools after measurement? Does it also need maintenance like aluminum plate? Are there any special requirements for the storage place? Firstly, the storage place of measuring tools shall be kept clean and dry, free of vibration and corrosive gas, and shall be far away from places with large temperature variation range or places with magnetic field. The measuring tools stored in the measuring box shall be clean and dry, and other sundries are not allowed to be stored.

1. After using the aluminum plate measuring tool, wipe the surface stains and aluminum chips, loosen the fastening device, and apply anti rust oil on the measuring surface when it is not used for a long time (more than 1 month). When the measuring tools are not in use, they shall be put into the protection box, used by a specially assigned person, and the annual review records of the measuring tools tested by the authoritative unit shall be made.

2. Do not rub the surface of the measuring tool, the measuring surface and the scribed part with oilstone and abrasive cloth. Non measuring maintenance personnel are strictly prohibited to disassemble, refit and repair the measuring tool without authorization.

3. When there are burrs on the surface of aluminum plate, the burrs must be removed before measurement, otherwise the measuring tool will be worn and the accuracy of measurement results will be affected.

4. Do not touch the measuring surface of the measuring tool with your hand, because wet dirt such as sweat on your hand will pollute the measuring surface and make it rusty. Do not mix the measuring tools with other tools, and metal materials to avoid damaging the measuring tools.

5. It is not allowed to use the tip of the measuring claw of the aluminum caliper as a scratch needle, compass or other tools. It is not allowed to twist the two claws artificially or use the measuring tool as a chuck.